Kawasaki ZX7R(R) Cable Clutch Kits

Cable Clutch Kit Kawasaki ZX7RR
Cable Clutch Fitment ZX7R and ZX7RR
Cable Clutch Fitment ZX7R and ZX7RR Pic2
Kawasaki ZX7RR Lever Arm Angle Pic 1
Cable Clutch ZX7RR Pic1
Cable Clutch ZX7RR Pic3

<Click on main image to open gallery>

ZX7R Road DUN7005_01
ZX7R Road Kit DUN7005_01
ZX7R road cable stop comparison

<Click on main image to open gallery>

ZX7R Road DUN7006_01
ZX7R Road Kit DUN7006_01
ZX7R road cable stop comparison

<Click on main image to open gallery>

Race ZX7R and ZX7RR: This cable clutch kit mounts directly onto existing lugs on the clutch inner casing. It consists of lever arm with steel ball fitting, cable connector, mounting pin and angled cable stop.

Suitable for both ZX7R and ZX7RR models. Supplied with a silver steel push rod hardened at one end. The cable stop mounts on the casting for the generator.

For race application when the generator is removed. Generator blanking plates also available. 

Kit Number: DUN7002_01

Supplied with all fittings and cable; £220 (without cable £190)

Road ZX7R and ZX7RR:

Option A - Generator in situ-fitment

  • Fitment without the requirement to remove the generator. The upper right bolt (as pictured) can’t be removed when the engine is in the frame.

  • The cable stop bracket is stainless steel and has one-hole, upper left bolt, and a slot for the upper right bolt.

    • Uses existing bolts.

  • Dog leg lever arm to clear the generator.

  • Supplied with push rod for a standard clutch L275.5 +/-0.5

    • Alternative length for kit clutch upon request.​​

  • Cable has a mid-way adjuster

Kit Number: DUN7005_01 (generator in-situ fitment)

Supplied with all fittings and cable; £220 (without cable £190)

Option B - Access to generator bolts required / partial generator removal

  • Fitment requires generator partially removed or engine out frame.

    • If engine is in frame: bolts slackened then generator pulled out and turned anti-clockwise in the frame.

    • Longer bolt and cable stop bracket fitted upper right location. Matching bolt for upper left also supplied.

    • Replace generator taking care not to snag o-ring at rear.

  • Aluminum cable stop bracket aligns with side of generator.

  • Dog leg lever arm to clear the generator.

  • Supplied with push rod for a standard clutch L275.5 +/-0.5

    • Alternative length for kit clutch upon request.​

  • Cable has a mid-way adjuster

Kit Number: DUN7006_01 (generator partially removed)

Supplied with all fittings and cable; £220 (without cable £190)

© 2018 by Dunbar Race Engineering Ltd